m2c9295 DURNAGO E BUGGY CHASSIS

 These chassis are made using 1/8 inch(3.25mm) thick 7075 aircraft grade materials and clear anodized.

we have tested and tweeked these chassis to provide the racers a top notch chassis that will perform very well on all surfaces.

this model is made for the tracks with a high wear charastics such as we have in western states , up north and canada .

this model will give you a much longer chassis life than  other models as you can replace the steel skid plates and be back to a new

chassis thickness.

It is important to note that these skid plates fit flush to the bottom of the chassis and will not effect the droop settings and cause you to

scrub speed on the landings.

this model use the stock parts except where noted and is a perfect 50/50 balance for jumping.

I have added a new motor mount that is a solid 1 piece for the motor and diff mount. this model has proven to rock solid over the years

and will stop the stripped spur gear problems. We used the Durango gas front center brace (td320273) for the front brace.

Due to the motormount design it will be necessary to modify the Esc mount to fit. It can be done with a dremmel tool with very little effort.

The diff will be turned around so u will need to reverse the drive shafts.

You can also use the Durango gas spur gear and center  drive cup, but it would be necessary to order the mugen  rear gas buggy drive shaft (muge0259). for this conversion to work. Durango gas buggy will also work.

A big thanks to John ST. Ament for all the advise on this project. He will be our lead contact on this project.

If any of you guys have specific questions about this chassis and set up contact him on facebook or thru his email.

F1Freak1964@yahoo.com

DUE TO THIS BEING A SPECIAL LIMITED RUN CHASSIS PLEASE ALLOW 3 WEEKS FOR DELIVERY.



m2c9295 DURNAGO E BUGGY CHASSIS
Click To Enlarge
  • Item #: m2c 9295
Price $169.98
Availability Out-of-Stock